Skip to content

All recalls CPSC

CPSCConsumer productsRecalled Status: Ongoing

CPSC, Lite Machines Corp. Announce Recall of Motor Speed Controller

Mediumest. risk

Estimated risk

CPSC doesn't classify recalls by risk, so Recall Relay estimated the risk as medium from the hazard description. This is our estimate, not an official classification.

Hazard
The Fusion 35 motor speed controller may not operate properly, due to a weakness in a batch of integrated circuit (IC) chips. The (IC) chip can become hot and damage the controller. In certain instances, a malfunctioning IC chip can cause the helicopter motor to turn on for the several seconds before the power is disconnected, which can damage the helicopter or cause injury to the operator or bystanders.
What to do
Consumers should send the Fusion 35 speed controller to Lite Machines for a diagnostic test by the manufacturer. If the unit is defective, it will be replaced free of charge.
Products
  • Fusion 35 speed controllers (shipped with Corona electric helicopter kits)
Companies
Lite Machines Corp., Lite Machines Corporation
Where it was sold

These components were sold with the electric helicopter kits at hobby shops, from November 2001 through December 2001, for about $60.

Units affected
375
About this recall
The Fusion 35 speed controller, a small printed circuit board with wires extending from either side, is packed in a clear plastic bag separate from other radio system components, and carries the identification "Fusion 35 #30499" on its front plate.