Skip to content

All recalls CPSC

CPSCConsumer productsRecalled Status: Ongoing

GPU Angled Adapters Recalled Due to Fire and Burn Hazards; Manufactured by CableMod

Highest. risk

Estimated risk

CPSC doesn't classify recalls by risk, so Recall Relay estimated the risk as high from the hazard description. This is our estimate, not an official classification.

Hazard
The adapters' male connector can become loose, overheat, and melt into the GPU, posing fire and burn hazards.
What to do
Consumers should immediately stop using the recalled angled adapters and contact CableMod for instructions on how to safely remove their adapter from the GPU and for a full refund, including cost of shipping, or a $60 store credit for non-customized products, with free standard shipping. Consumers will be asked to destroy the adapter and upload a photo of the destroyed product to https://cablemod.com/adapterrecall/. The instructions on how to safely remove the adapter are also located on that site. Once destroyed, consumers should discard the adapter in accordance with local laws.
Products
  • CableMod Graphics Processing Unit (GPU) V1.0 and V.1.1 Angled Adapters
Company
CableMod Ltd.
Where it was sold

Small independent stores nationwide and online at vprbrands.com from September 2022 through November 2023 for about $18.

Nationwide

Units affected
About 25,300
About this recall
This recall involves CableMod's 12VHPWR Angled Adapters, models V1.0 and V1.1, that plug into a graphics processing unit's power port at either a 90-degree or a 180-degree angle. Model V1.1 has a stabilizing pin on the side of the male connector. The adapters were sold in black, blue, gold, green, orange, pink, purple, red, silver, and white, and "CableMod" appears on the side of the adapter. The adapters came in two variations to accommodate power port orientation: Variation A and Variation B. The 90-degree angle adapter is "L" shaped: The V1.0 model measures about 36 mm long, 21mm wide and 21 mm deep; and the V1.1 model measures about 36 mm long, 21 mm wide and 22 mm deep. The 180-degree angle adapter is "U" shaped: The V1.0 model measures 41.5 mm long, 21 mm wide and 17.5 mm deep; and the V1.1 measures about 41 mm long, 21 mm wide and 20 mm deep.